Jeep WRANGLER B7659 - Manual (Page 11)

11
• Fit the wide notch in the side of a headlight lens under
the wide tab on a lens guard.
• Press firmly on the inside of the headlight lens to snap it
into the lens guard.
• Repeat this procedure to assemble the other headlight
lens to the remaining lens guard.
Lens
Wide
Notch
Wide Tab
Lens Guard
Assembly
• Fit the lens tabs on the back of a lens assembly into the
headlight slots in the grille.
• Press firmly to snap the lens assembly into the grille.
• Repeat this procedure to snap the other lens assembly
into the grille.
Grille
Tab
Tab
Slot
Slot
10
11
Steering Wheel
• Fit the steering wheel cap into the center of the
steering wheel.
• Insert two #8 x 1" screws, as shown.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Steering
Wheel Cap
9
• Turn the vehicle upright.
• Position the steering wheel so that the spokes form a
“Y” as shown. The tab on the steering wheel stem
should face up.
• Fit the steering wheel onto the steering column.
• Fit a cap nut onto the end of the steering column.
• Tap the cap nut with a hammer to secure it on the
steering column.
Hint: You may want the help of another person to
support the steering column while you tap the cap nut
with the hammer.
Steering Wheel
Cap
Nut
Steering
Column
“UP”
Tab
8
.354"
.354 Cap Nut