Jeep WRANGLER B7659 - Manual (Page 14)

14
• Fit a support to one side of the sport bar.
• Insert a #8 - 32 x 1.625" screw through the support, the
sport bar and out through the support.
• Fit a lock nut to the end of the screw.
• While holding the lock nut with the pliers, tighten the
screw with a Phillips screwdriver. Do not over-tighten.
Sport Bar
Supports
Assembly
• Insert a #8 x 1" screw into the rear of seat, as shown.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
20
21
• Fit the light covers to the lights on the sport bar, as shown.
• Insert a #10 x 1 /
2
" screw through the light cover and into
the light. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Light
Covers
Lights 22
Dash View