GE RM24927 - Manual (Page 5)

9 8
Write your codes down here for easy reference
later.
Direct Code Entry
1. Press and hold the CODE SEARCH
button until the red indicator stays on,
then release the CODE SEARCH button.
2. Press and release the desired device
button (TV, VCR, etc.). The red indicator
blinks, then stays lit.
3. Enter the 4 digit code
from the code tables
(on separate sheet).
Note: after a valid code
entry, the red indicator
turns off. For an invalid
code, the red indicator
flashes.
4. With your device on, press
ON•OFF . If the device turns off, no
further programming is required.
Note: If some buttons do not
operate your equipment, try one of
the other codes for your brand.
The surround sound feature may be turned ON/OFF
by pressing the SURR
ON•OFF button.
Surround Sound Feature
Type Type stored Code
TV TV
VCR1
VCR2
SAT
CBL
AUDIO
DVD
AUX
1. Press the SURR MODE button
until the desired mode is found.
2. Press DELAY+ or DELAY- to achieve the desired
delay affect.
3. Press the DSP ON•OFF button to
turn DSP (Digital Sound Processor)
ON or OFF.
4. Press the DSP mode button until the
desired effect is achieved.
5. Press the TEST button to listen to
speaker levels.
7. Press the LEVEL+ or LEVEL-
buttons to adjust speaker levels.
6. Press FRONT, CENTER,
or REAR buttons to
select speakers.