JAI CV-M10 - Manual (Page 16)

CV-M10BX/CV-M10RS
- 13 -
8.6.3. Location of Jumper for CV-M10BX on PK8206A
Jumpers for selecting random trigger modes for CV-M10BX. It is edge pre-select, pulse width control, H reset and H non-
reset.
Jumper for trigger input 75 ohm termination is also found here.
8.6.4. Location of Jumper for CV-M10RS on PK8190A
Jumpers for selecting random trigger modes for CV-M10RS. It is edge pre-select, pulse width control, H reset and H non-
reset. These modes can not be selected by RS232C.
Jumper for trigger input 75 ohm termination is also found here.
JP12 JP13
JP10
JP12
JP13 JP10