JAI CV-M10 - Manual (Page 6)

CV-M10BX/CV-M10RS
- 3 -
5. Pin Assignment
5-1. 12-pin Multi-connector (DC-IN/SYNC.)
Type: HR10A-10R-12PB-01 (Hirose) male seen from rear.
!
"
#
$
%
&
'
Notes: *1) Signals on pin no. 6, 7 and 9 can be changed by jumper setting.
See "8. Jumper Settings" for more information.
*2) In Edge Pre-select and Pulse Width Control mode do not input ext. VD signal.
5.2. 6-pin Multi-connector (RS 232C/TRIGGER)
Type: HR10A-7R-6PB (Hirose) male seen from rear.
Note: WEN is generated in Normal Trig, Random Trig (normal and high speed
shutter) and Low Speed Shutter. It is 1 H long and indicates the beginning
of video read out.
Pin no. Signal Remarks
1 GND
2 +12 VDC input
3 GND
4 Video 1 output Parallel with the BNC video 1 output. Avoid double termination.
5 GND
6 HD input/output Ext. HD in as factory setting. *1)
7 VD input/output Ext. VD in as factory setting. *1) *2)
8 GND
9 Video 2 output Video 2 only in 2:1 interlace. Pixel clock output. Opt. *1)
10 GND
11 +12 V DC input
12 GND
Pin no. Signal Remarks
1 TXD out NC on BX version
2 RXD in NC on BX version
3 GND
4 NC
5 Ext. Trig input
6 WEN output * Note
! "
#
$