Jensen JiSS-250i - Manual (Page 7)

6
seconds to switch off the device and then gently remove it from the docking connector.
10. To turn JiSS-250i off, press the STANDBY Button again.
Note:
i.
The System will automatically enter sleep mode 5 minutes after playback stops and switch to
standby mode automatically after 30 minutes of no activity. In Sleep mode the LED will flash
and in standby mode, the LED will go off.
ii. The AUX In function is in higher priority than the iPod function. Make sure the AUX IN Jack is
unplugged when you are going to enjoy the iPod music, otherwise the music of the iPod won’t
be heard.
iii. Your iPod/iPhone will only be charged when the System is powered by AC.
AUX IN OPERATION
You can play other music sources (MP3 or other digital audio players) through the speakers of this
System by connecting the AUX IN Jack to your external player’s audio out jack or headphone jack.
1.
To turn the JiSS-250i on, press the STANDBY Button on the front panel.
2. Plug one end of an audio cable (included) into the AUX IN Jack and the other end of the cable
into the headphone jack of your digital audio player.
3. Start playing the device plugged into the AUX IN jack.
4. Adjust both the volume controls on the JiSS-250i and your external player for a comfortable
listening level.
5. Turn off your external player when you have finished listening. Turn the JiSS-250i off and
unplug the AUX IN jack.
CARE AND MAINTENANCE
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent
lamps or motors.
3. For better Display clarity, avoid operating the unit under direct sunlight or in strong room
illumination.
4. Unplug the unit from the electrical power outlet immediately in case of malfunction.