John Lewis JLWM1202 - Manual (Page 13)

13
• The washing machine has stopped with water in
the tub, at the end of the “Soak 30°” or a
programme with the “Quiet” option: this is indicated
by a flashing zero.
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the Start/Pause button, the
countdown is updated every hour, and, for the last
two hours, every 30 minutes.
• An incorrect option selection has been made:
this is indicated by the message Err when a function
incompatible with the current programme is selected.
0
6 Start/Pause button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light above the button will stop flashing
and remain lit.
If you have selected a delay time, the countdown will
begin and will be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme from the point at which it was
interrupted, press the button again.
When you PAUSE the cycle, and it becomes possible
to open the door, provided:
• the washing machine is not in the heating phase;
• the level of the water is not high;
If all these requirements are met, the door locked light
goes off.
Important! You must set the washing machine to
Pause before you make any change in the programme
in progress.
7 Display
The following pieces of information are shown on the
display:
• Duration of washing programme in hours and
minutes, after you have selected a programme.
While the programme is running (after you have
pressed the Start/Pause button), the displayed time
value decreases by one unit every minute.
• The washing machine has completed the
programme: this is indicated by a flashing zero.
2.05