John Lewis JLWM1202 - Manual (Page 17)

17
6. Select the spin speed or the
“None” option
Press the “Spin” button repeatedly button if order to
select the desired spin speed or the “None” (no spin)
option.
The relevant light will light up.
JLWM 1202 JLWM 1403
7. Select the desired options
If your laundry is very dirty, it may be advisable to
select the “Prewash” option or the “Intensive”
option.
If your laundry has heavy stains and it is necessary to
prolong the washing time, select the “Stain” option.
The special detergent for stains (Stain remover) is
loaded from the compartment marked
.
If you wish the laundry to undergo an extra rinse,
select the “Extra Rinse” option.
If your laundry should not be creased, select the
“Quiet” option to leave the fabrics in the water of the
last rinse.
The relevant light illuminates.
Stain Prewash Quiet Intensive
Extra
rinse
1400
900
700
500
None
Spin
1200
900
700
500
None
Spin
9. Select the “Delay start”
Before you start the programme, if you wish the
start to be delayed, press the “Delay Start” button
repeatedly, or keep it pressed, to select the desired
delay. The selected delay time value (up to 23 hours)
will appear on the display for 3 seconds, then the
duration of the programme will appear again.
10. Start the programme
Press the “Start/Pause” button. The relevant light will
stop flashing, and only the light relevant to the phase
that is in progress will remain lit.
If you have chosen a delayed start, the washing machine
will begin the countdown.
The display will show the duration of the programme
or the selected delay.
11. How to change an option
or a programme during its
cycle
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the “Start/Pause”
button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to “Off” and then
to the new programme position. The washing water in
the tub will not emptied out .
Start the new programme by depressing the
“Start/Pause” button.
Delay
start