Disc care and handling, Use only discs marked with the following logo, Troubleshooting – Jensen MCDA1 User Manual

Page 26: Specifications, Specifications subject to change without notice, Mcda1 disc care and handling

Advertising
background image

26

MCDA1

Disc Care and Handling

Dirt, dust, scratches and warpage can cause skips in the playback and deterioration of sound
quality. Please follow these guidelines to take care of your compact discs.
1.

Use only discs marked with the following logo:

2.

Carefully wipe fingerprints, dust and dirt from the disc’s
playing surface with a soft cloth. Wipe in a straight motion
from the inside to the outside of the disc.

3.

Never use chemicals such as record sprays or household
cleaners to clean CD’s, as they can irreparably damage the disc’s surface.

4.

Discs should be kept in their storage cases when not in use.

5.

Do not expose discs to direct sunlight, high temperatures or high humidity for long periods.

6.

Do not stick paper, tape or labels on disk surfaces.

Troubleshooting

Problem

Cause

Correction

No power

Improper connection

Check connections

Magazine cannot be installed

Inserting in improper direction

Insert in proper direction

CD changer does not operate

Fuse blown

Locate and replace fuse

Bad ground to CD changer

Locate and repair ground

CD changer overheated

Allow air to circulate around changer

Magazine not installed/no discs in
magazine/discs installed
incorrectly

Install discs and magazine

Disc does not play

Disc is loaded upside down

Load disc with the label facing up

Disc is playing but there is no
sound

Fuse blown

Locate and replace fuse

Condensation (moisture) on CD
changer laser optics (occurs in
humid, rainy conditions or after
turning on the heater)

Remove magazine, leave CD
changer door open and wait
approximately one hour

Music “skips” excessively when
going over bumps, or noise is
heard during playback

Shipping screws not removed

Remove shipping screws

Vertical/horizontal anti-vibration
spring position not selected
correctly

Select correct position

Disc is warped or contains large
scratches

Try playing another disc; if the
second disc sounds fine, the first
disc is most likely defective

Disc is extremely dirty

Clean disc

New disc does not operate
propely (does not play, skips to
the next CD, disc repeats)

Burrs in the center hole or outside
circumference of the disc

Using the side of a ball point pen (or
similar implement), trace around or
inside disc to remove burrs

Specifications

Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20Hz-20kHz (-3dB)
Signal to Noise Ratio @ 1kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >90dB
Stereo Separation @ 1kHz. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >65dB
THD+N @ 1kHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <.01%
FM Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5uV)
AM Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10uV
Weather Band Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7uV
Audio Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 channels @ 62.5 Watts
Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14.4VDC (10-16VDC allowable), negative ground
Fuse . . . . . . . . . . . . . . . . . . . . . . . . . . 5 amp (battery), 0.5 (accessory/ignition), glass type, fast blow
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 5/8" x 3 3/8" x 7 2/8" (245mm x 85mm x 180mm)

Specifications subject to change without notice.

Advertising