JVC Model MX-J70J - Manual (Page 13)

– 10 –
Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built
in this unit.
1 Press PANEL OPEN/CLOSE.
The unit is turned on and the Powered Rolling
Panel opens automatically.
2
Press TIMER/CLOCK.
The hour digits start flashing on the display.
3 Press
4 or ¢ to adjust the
hour, then press SET.
• If you want to correct the hour after pressing
SET, press CANCEL. The hour digits start
flashing again.
4
Press
4 or ¢ to adjust the
minute, then press SET.
To adjust the clock again
If you have adjusted the clock before, you need to press
TIMER/CLOCK repeatedly until the clock setting mode is
selected.
• Each time you press the button, the timer/clock setting
modes change as follows:
If there is a power failure
The clock loses the setting and is reset to “AM 12:00.” You need to
set the clock again.
Turning On the Power and Selecting the
Sources
When you press the play button for a particular source (FM/
AM, CD
6, AUX, and TAPE 2 3), the unit turns on, and
the Powered Rolling Panel opens automatically (and the unit
starts playing the source if it is ready — COMPU PLAY
CONTROL).
To listen to the FM/AM broadcasts, press FM/AM. (See
page 13.)
To play back CDs, press CD
6. (See pages 14 – 16.)
To play back tapes, press TAPE
2 3. (See page 17.)
To select the external equipment as the source, press AUX.
To turn on the unit without playing, press
POWER so that the STANDBY lamp goes off.
The Powered Rolling Panel opens automatically.
To turn off the unit (on standby), press POWER
again so that the STANDBY lamp lights up.
The Powered Rolling Panel also closes.
A little power is always consumed even while the
unit is on standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “AM 12:00” right away, while the tuner preset
stations (see page 13) will be erased in a few days.
Adjusting the Volume
You can adjust the volume level only while the unit is turned
on.
Turn VOLUME clockwise to increase
the volume or counterclockwise to
decrease it.
When using the remote control, press VOLUME + to increase
the volume or press VOLUME – to decrease it.
For private listening
Connect a pair of headphones to the PHONES jack. No sound
comes out of the speakers. Be sure to turn down the volume before
connecting or putting on headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, a
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source.
REMEMBER you cannot adjust the volume level
while the unit is on standby.
TIMER
/CLOCK
STANDBY
POWER
STANDBY
POWER
DAILY
Canceled
ON TIME
ON TIME Clock
setting
(The hour digits start flashing.)
REC
FM AM / C D TAPE
AUX
PANEL
OPEN / CLOSE
SET
SEA CONTROL
SET
SEA CONTROL
PRESET
PRESET
Continued
VOLUME
+
–
EN01-13.MX-J70[J]/f 99.2.9, 1:31 PM 10