JVC Wide LCD Panel TV LT-23B60SJ - Manual (Page 19)

ENGLISH - 18 -
Selecting Band
Band, can be chosen either,
• “C” or “S” by “ ” or “ ” button.
Selecting Channel
Channel can be changed by “ ” or “ ” button
or by Digit Buttons.
Selecting Colour System
Using “ ” or “ ” button on Colour System,
you can change the colour system to PAL,
SECAM or Auto.
Note: In EXT mode, you can choose NTSC
3.58 and NTSC 4.43 as well.
Selecting Sound System
Using “ ” or “ ” button on Sound System,
you can change the standard to BG, DK, I, L,
Lp.
Selecting Fine Tuning
You can use the Fine Tuning process for fine
adjustment (after coarse adjustment), if you
are not happy about the image on the screen.
Use “ ” or “ ” button on Fine Tuning item,
until getting the best image on the screen.
Selecting Search
To start the search process, press “ ” button
for forward search or “ ” button for backward
search. If a signal is found or reaches to end
of the band after searching, press “ ” or “ ”
buttons to continue search process. To stop
the search process when you want, press
“ ” or “ ” buttons at any time.
Decoder(EXT-2)
You can use this mode to connect any de-
coder to your TV.
• Press the “ ” or “ ” buttons to set it “On” or
“Off”.
When you select Decoder(EXT-2) “On”,
EXT-2 output will be chosen as TV mode only
and any scrambled channels will be un-
scrambled through decoder connected your
TV via EXT-2 output.
Setting VCR (Video Cassette Recorder )
Mode
• This item can be seen in
TV, EXT-1, EXT-2
and EXT-3 modes.
• If you want to watch a VCR source from one of
these modes, then it will be better to set
VCR mode “on”. For this, while the cursor is
on this item press the “ ” or “ ” buttons to
set it “On”.
• If you want to watch a DVD , then you must set
this item “off”; because DVD is not a source
like a VCR and to see the picture better, you
must set the VCR mode “Off”.
To Store Settings
• Press “ ” / “ ” or “OK” button on Store op-
tion to store Install menu settings.
• After stored, T-V Link menu will appear. If you
do not need to do T-V Link, select Cancel
and press “ ” or “OK” button to exit the menu.
Program Menu
Press “MENU” button, now you are in main
menu. In the main menu, select “Program”
using “ ” or “ ” button. Then enter the
Programme menu
by pressing “ ” / “ ” or
“OK” button.
Note: There is no Program menu in any EXT
modes.
Program Menu is used to delete a channel, to
change the programme number of a channel,
to give a channel name to a channel, and to
start the A.P.S (Autostore) function.
01-ENG-2325W-17MB08P-1861UK-(LT-23B60SJ)_02062005.p65 02.06.2005, 10:56 18