GE 94925 GE Universal Remote - Manual (Page 11)

10
Programming For Audio
This remote control will operate many fea-
tures found in audio/video receivers and
mini-systems. The remote control is already
programmed to operate most GE, RCA and
ProScan brand A/V receivers. Other brands of
receivers and mini-systems need to be set-up
under the AUDIO button prior to using the
device.
1. Manually turn on the device you wish
to control. Find the three digit code for the
device you wish to control in the code list
below.
2. Press and hold the
CODE SEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release
the AUDIO button (The
INDICATOR LIGHT will
blink then remain lit.
4. Enter the code using
the Number Buttons.
After your code is
entered, the INDICATOR
LIGHT will turn off. If
the code is not valid, the
INDICATOR LIGHT will
blink. Check the code list
and repeat process.
5. Aim the remote at
the device you wish to
control and press the
ON•OFF button. The
device should turn off.
6. With your device
on, press VOL+ (Volume
up). If the device responds, no further pro-
gramming is required.
NOTE: If your device does not respond, try all
the codes for your brand. If the codes do not
work, or your brand is not listed, try the Code
Search method.
7. Enter your code and the type of device
youprogrammed here for easy reference.
AUDIO CODE
VOL
ON•OFF
1 2 3
4 5 6
7 8 9
0
(OFF)
(BLINK)
INDICATOR
LIGHT
AUDIO
CODE
SEARCH
CD RCVR LD