JVC CA-D672TR - Manual (Page 35)

31
English
Auto Edit Recording
Using Auto Edit, you can record the CD tracks to fit the tape, so a selection isn’t cut off. Auto Edit is
one of the best ways to copy all of a CD onto a tape.
Auto Edit programs the CD tracks in numerical order. To prevent the end of the last track on the
front side from being cut off, the last track on the front side is selected to fit on the remaining tape
length.
1.
Prepare CDs. (See page 19.)
2.
Press the EDIT button on the Unit.
“DISC-” appears in the display.
3.
Press the DISC button for the disc you want to record.
After “TAPE C - -” appears on the display, the optimum tape length for the disc you want to
record is displayed.
❏ You can select a different length of tape, depending on the actual size of the tape you are
using, from eleven possibilities programmed into the CA-D672TR: 40, 46, 50, 54, 60, 64,
70, 74, 80, 84, 90. Select the tape length that corresponds to the length of tape you are using,
or the nearest length to it, by adjusting the MULTI CONTROL stick left or right.
•
If you pick a tape length shorter than the total playing time of the CD, the last tracks on
both sides of the tape will be faded out as the tape ends.
4.
Press the SET button.
The tracks to be recorded on side B of the tape appear on the display.
❏ To display the tracks that will be recorded on side A of the tape, press the SET button again.
The Unit switches between side A and side B with each press of the SET button.
❏ To check the tracks that will be recorded, press the 4 or ¢ buttons on the Remote
Control.
5.
Insert a cassette in Deck B to record on.
When you want to record on both sides of a tape, press the REVERSE MODE button to turn
Reverse mode on.
6.
Press the CD REC START button.
The Unit plays the CD and starts recording. If the tape has not been rewound, the Unit rewinds
the tape before starting to record the CD.
When the tape is ready, to prevent the start of a track being cut, the CA-D672TR creates a blank
period of 10 seconds before it starts to record the CD. While a blank period is being created,
“TAPE SIDE-A STANDBY” scrolls through the display. (The CA-D672TR also creates a 10
second blank period at the start of side B of the tape. While a blank period is being created,
“TAPE SIDE-B STANDBY” scrolls through the display.)
When the recording is finished, the message “CD REC FINISHED” scrolls by on the display.
The CD Player and Cassette Deck stop.
EDIT
DISC
DISC
DISC
SET
SOUND
MODE
VOL
CD
SOUND
MODE
VOL
SET
CD
SOUND
MODE
5 7 8 6
VOL
CD
CD REC START REC
START/STOP
DUBBING
EN01-42.CA-D672TR[E]/F 05.3.24, 9:29 PM 31