JVC HR-VCD1 - Manual (Page 23)

23
English
Karaoke Features (cont’d)
3 Hang the FM feeder cable on the wall behind the Player
so that the cable forms a “T”.
2 Release the lever.
If there is interference when using the micro-
phone
Follow the steps below to re-adjust the frequency of the micro-
phone and your Player.
Preparation
1. Turn on your TV and Player.
2. Select the TV’s VIDEO channel.
3. Press the WIRELESS MIC button on the Player's front
panel.
Ⅵ The WIRELESS MIC indicator will light.
4. Set the microphone’s MIC select switch to “WL. (Wireless)”.
5. Turn the MIC knob on the front panel of the player in order
to adjust to the desired sound volume.
6. Set the MIX VOL knob on the player's front panel to the
center or VCD.
Operation
1. Turn tightly the FREQ. screw on the Player's rear panel in
either direction with the provided screwdriver (attached at
the rear of the battery compartment).
2. While speaking into the microphone continuously. Turn the
microphone’s FREQ. screw with the provided screwdriver
in the same direction as in step 1. until your voice can be
clearly heard from the TV’s speaker.
Check
1. First set the microphone’s MIC select switch to “OFF”. And
set the switch to “WL. (Wireless)”.
2. Speak into the microphone and check if your voice can be
heard from the TV’s speaker.
Ⅵ
If your voice cannot be heard. Try again steps 1 and 2 of
“Operation”.
To use the microphone as a wireless microphone
You need to connect the provided FM feeder cable to the
Player.
1 While you press the lever, connectors, insert the pro-
vided FM feeder cable into the connectors.
Preparation
The Karaoke Control Centre on the Player’s front panel
gives you direct access song search, and sound volume/
echo control. The provided microphone can also be used
as a wireless microphone.
WIRELESS MIC ANT.
FREQ
ADJUST
AUDIO R
AUDIO L
VIDEO
OUT1 OUT2
NT8C3.58
NTSC4.43 NTSC ON PAL TV
WIRELESS MIC ANT.
FM feeder antenna