JVC HD-61Z786 - Manual

LTIP/TS-CL110UAA
R EPLACEMENT L AMP FOR JVC LCD R EAR P ROJECTION T ELEVISION
M ODELS HD61Z786 / HD61Z886 / HD70G886 / HD61Z585 / HD61Z575 / HD52Z575 / HD52Z585 / HD56G786
R
EPLACING THE
L
AMP
U
SER
I
NSTRUCTIONS
CAUTION:
Do not attempt to remove the lamp immediately after use; doing so can cause serious burns. Prior to removing lamp, switch
off the power supply to the television and wait approximately 60 minutes or more to allow for complete lamp cooling.
Avoid touching the glass portion(s) of the lamp with bare hands; fingerprints, dirt and dust may cause early lamp failure
and/or image obscurity. It is recommended that gloves be worn when replacing the lamp.
When transporting the replacement lamp, use the box that is provided to avoid breakage.
.
.
.
To avoid overheating and/or fire, ensure that the replacement lamp is mounted securely.
The lamp contains mercury. Dispose of it in accordance with local environmental regulations. For disposal or
recycling information, contact your local authorities or see www.lamprecycle.org.
.
. WARNING:
1. Switch off power to the television and wait until the picture disappears and the LAMP LED on the front panel has
stopped blinking. Unplug the power cord from the wall outlet. Allow the television to cool for at least 1 hour.
®
4. Remove the lamp cover and set aside. (First, loosen the screw located on the lamp cover using your fingers or a Philips
screwdriver. Once the screw has been loosened, gently pull the knob towards you and the panel will come away from the
television.)
Note: There are three ways to remove the lamp cover, depending on the television type. Please refer to your television’s
instruction manual to determine which type you have.
2. Remove the screw from the rear panel using your fingers.
The screw is located under the right rear panel.
p. 1
I F YOUR LAMP DOOR IS LOCATED BELOW ON THE LEFT SIDE OF YOUR TELEVISION , SKIP STEPS 2, 3, 10 AND 11.
3. Remove the left speaker panel located at the bottom of the front panel and set aside.
Note: There are two ways to remove the panel, depending on the television type. Please refer to your television’s
instruction manual to determine which type you have. You will remove the panel by either pulling it towards you, or by
pulling it from the left towards you.
or
or or