JL Audio MCS-3800 User Manual
Page 13
13
Expander Connection
The MCS-3000X Expanders may be physically attached to the
MCS-3400 or MCS-3800 Controller, forming a continuous
control surface.
(MCS-3800 shown with 3 MCS-3000X Expanders attached)
Alternately, the Expander can stand apart from the MCS
Controller. In that case, an optional set of simulated stone end-
bells may be purchased to make the Expander more attractive.
(MCS-3000X shown with Optional End Bells attached.)
The instructions for physical interconnection, and electrical
hookup are on the following pages.
84
Initialization
To clear the memory of the MCS-3800, and restore the Factory
Preset settings, hold both the
UP and DOWN cursor buttons while powering up the unit.
Initialized Settings
From JLCooper, the MCS-3800 or MCS-3400's user-assignable
memory is initialized to a “Factory Preset” set of (mainly)
Controller messages on MIDI Channels 2 through 16.
The exceptions are the Transport switches, which are
initialized to send MIDI Machine messages and (if option card
is installed) Sony 9-pin messages.
The initialized values are as follows:
(MIDI Channel is shown in base 10, Controller # is in Hex)
Switch
MIDI Channel Controller #
F1
16
00
Shifted F1
“
01
F2
“
02, etc.
Shifted F8
“
0F
W1
“
10
Shifted W1
“
11, etc.
Shifted W7
“
1D
M1
“
1E
Shifted M1
“
1F, etc.
Shifted M5
“
27