JL Audio MCS-3800 User Manual
Page 80
17
(2) To Use 3000X “Stand Alone” without an MCS-3800
Set the rear DIP switch position #4 down (= ON)
When the rear dip switch number 4 is down, that is, on, you
will use the MCS-3000X’s MIDI input and MIDI output.
(The MCS-3000X’s modular “telephone-type” connectors are
not used in this modes)
When the rear dip switch number 4 is down, that is, on, the 3
remaining switches are used to select the protocol, that is, the
input and output MIDI commands.
Information about the stand-alone protocols is covered in a
separate document.
DIP Switch Setttings for Protocol Selection
Note that the switches are mounted upside down.
Switch #4 is the left most switch, when viewed from the rear.
Up = off.
#4
#3
#2
#1
Mode
on
off
off
off
0
on
off
off
on
1
on
off
on
off
2
on
off
on
on
3
on
on
off
off
4
on
on
off
on
5
80
Jog
Sets responsiveness of Jog Wheel. Range is 1 to 100.
When controlling a digital audio workstation, there are several
factors that will affect the responsiveness of the wheel, in
addition to the Speed.
Some software applications feature a view of the audio
waveform, allowing the user to "zoom in" and "zoom out" of
the waveform. When "zoomed in", some applications produce
a slower and finer Jog. While "zoomed out", these applications
jog at a faster rate.
In addition (very important), your application may also have a
software preference file for setting Jog responsiveness.
Shuttle
Shuttle Speed range is 1x, 2x, 4x, 16x, and 32x.
That is, when the Shuttle Ring is rotated as far as its goes, the
machine will play up to 32 times normal play speed.