JVC YU30052-513-2 - Manual (Page 13)

13
T
W
T
W
T
W
T
W
FEATURE: Zooming
PURPOSE: To vary the length of the focal lens and
produce zoom in/out effect.
OPERATION: Zoom In
1) Pull the power zoom switch down
toward “T”.
Zoom Out
2) Push the switch up toward “W”.
NOTES: ● The further the power zoom switch is
pushed or pulled, the faster the zoom
speed becomes.
● Focusing may become unstable
during zooming. In this case, set
zoom while in Record–Standby, set
manual focus or Focus Lock
(
੬
pgs. 20, 21), then zoom in or out
in Record mode.
FEATURE: Quick Review
PURPOSE: To check end of last recording for
confirmation.
OPERATION: 1) Press “ ” for less than 2 seconds
during Record–Standby mode.
•Tape is rewound for about 2
seconds and played back automati-
cally, then pauses in Record–
Standby mode for next shot.
NOTE: Distortion may occur at start of
playback. This is normal.
FEATURE: Retake
PURPOSE: To re-record certain segments.
OPERATION: 1) Make sure camcorder is in Record–
Standby mode.
2) Press either RETAKE button to reach
start point for new recording.
3) Press Recording Start/Stop to start
recording.
NOTE: Noise may appear during Retake. This
is normal.
RETAKE
Power zoom switch
Zoom indicator
RECORDING Basic Features
Zoom-in
Zoom-out