JVC SR-DVM700U User Manual

Page 59

Advertising
background image

EN

59

SYSTEM CONNECTIONS

These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.

1

Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.

NOTES:

For Dolby Digital sound, set

ADIGITAL AUDIO OUTB to ADOLBY

DIGITAL/PCM

B. (A pg. 60)

For DTS sound, set

ADIGITAL AUDIO OUTB to ASTREAM/PCMB.

(

A pg. 60)

CAUTIONS:

This unit has a dynamic range of more than 110 dB with regards
to its Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to
the speakers may damage them.

Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely
affect the playback picture.

When you can’t switch the audio channel of a bilingual

program
When the unit is connected with a digital audio device using an
optional optical cable and

ADIGITAL AUDIO OUTB is set to

ADOLBY DIGITAL/PCMB, it is not possible to switch the audio
channel of a bilingual program recorded on a DVD-RAM or DVD-R/
RW (VR mode) disc. In this case, perform the following steps using
the remote control to switch

ADIGITAL AUDIO OUTB from ADOLBY

DIGITAL/PCM

B to APCM ONLYB.

A Press SET UP to access the Main Menu screen.

B Press selection keys to select ADVD VIDEO SET UPB, then

press

G.

C Press selection keys to select AAUDIO OUTPUTB, then press

G.

D Press selection keys to select ADIGITAL AUDIO OUTB, then

press ENTER.

E Press selection keys to select APCM ONLYB, then press

ENTER. (

A pg. 60)

F Press SET UP to complete the setting.

G Press AUDIO to select the desired audio channel.

Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS

Dolby Digital Decoder or

amplifier with built-in DTS

Coaxial cable

(not supplied)

Rear of unit

Note for connection:
Remove the protection cap from the optical cable.

To [DIGITAL AUDIO

OUTPUT

(COAXIAL)]

To DIGITAL AUDIO input

Optical cable
(not supplied)

To [DIGITAL AUDIO
OUTPUT (OPTICAL)]

Advertising