JVC TD-EX90 - Manual (Page 10)

10
TD-EX90
Tape playback
Three tape types including normal (Type I), High position (Type II) and Metal (Type IV) tapes can be
played back. The type of tape is identified automatically by the cassette deck.
1 Press
0.
The tape tray comes out open.
Shortcut:
Pressing
0 while the power is in the STANDBY mode
automatically switches the power ON and opens the
tape tray.
2 Place a tape on the tray, with the side A facing
up.
Fit in the caved-in area so that the edge where tape is
exposed faces toward the inside of the unit.
3 Press
0.
The tape tray closes.
4 Press
¤ or ‹.
Playback starts.
• Pressing ‹ starts playback of side A (top side). The
£ indicator blinks slowly.
Pressing
¤ starts playback of side B (bottom side).
The
™ indicator blinks slowly.
• If ¤ or ‹ is pressed while the tape tray is open, the
tape tray closes before playback starts.
Shortcut
Pressing
¤ or ‹ while the power is in the STANDBY
mode automatically switches the power ON and starts
playback.
Note: It will take about 6 seconds to start playing.
• Press
7 to stop playback in the middle.
• Press 0 to eject the tape.
Caution
Playback may be interfered with noise if there is a TV set nearby. In this case, turn off the TV or
increase the distance between the TV and this unit.
Playback
1-23.TD-EX90[J]/1 5/12 98.6.4, 11:59 AM 10