JVC TD-EX90 - Manual (Page 15)

15
TD-EX90
MD synchronized recording
Synchronized recording makes it possible to start cassette recording in synchronism with the
playback of the MD recorder.
Be sure to make the Compu Link connection among the EX series components.
1 Load the tape for use in recording.
Press
0 to open the tape tray, place a tape on it and
press 0 to close it.
• It is not possible to record onto a cassette tape with
the broken accidental erasure tab. Use a cassette the
tab of which is not broken.
• If you want to record music on both sides of tape
continuously, switch the reverse mode on (see page
13).
• If you want to use Dolby Noise Reduction, press
DOLBY NR to select B or C (see page 13).
2 Prepare the MD recorder.
Load the MD to be played.
Program MD tracks if required.
* Refer to the instruction manual of the MD recorder
for the MD recorder operating procedures.
3 Press REC PAUSE.
The cassette deck enters record-pause mode.
4 Press
‹/8 of the MD recorder.
Synchronized recording starts.
To stop recording:
Press
&/CANCEL of the MD recorder to stop recording.
The cassette deck will stop after leaving a non-recorded
blank of 4 seconds.
If you want to stop recording immediately, press
7 of
the cassette deck.
CD REC REC PAUSE
/CANCEL
1-23.TD-EX90[J]/1 5/12 98.6.4, 11:59 AM 15