John Deere LPBST-35JD - Manual (Page 6)

Installing - 5
INSTALLING
MX39207
2. Install 3/8 in. ID O-ring (E) on transmission shaft (F) until seated on
bottom of hopper (G).
3. Install agitator (H), and secure with 1/8 x 1 in. cotter pin (I) through top
loop in agitator and hole in transmission shaft, as shown.
MX39208
4. Make sure transmission bracket (J) is on top of nuts (K) on hex bolts (L),
and install control support tube (M) onto bolts (L). Secure with 5/16 in.
locknuts (N). Tighten locknuts.
MX39209
5. Install hitch clevis brackets (O) onto tow tube end (P) with two 5/16 x 2
in. carriage bolts (Q) and 5/16 in. locknuts (R), as shown. Tighten
hardware.
6. Install 1/2 x 2-1/2 in. hitch pin (S) and 1/8 in. spring locking pin (small)
(T) through end of clevis brackets, as shown.
Installing
Installing the Spreader
1. Park machine safely. See “Parking Safely” in Safety section.
MX39210
2. Remove 1/8 in. spring locking pin (A) and 1/2 x 2-1/2 in. hitch pin (B)
from hitch clevis (C) of spreader.
3. Pull spreader forward and position hitch clevis to straddle machine rear
hitch plate or drawbar (not shown). Align all hitch pin holes, then install
hitch pin down through hitch clevis and machine hitch, securing with 1/8
in. spring locking pin (small).
IMPORTANT: Avoid damage! To avoid transmission damage, do
not adjust slot in transmission bracket forward or rearward. The
slot will self center as hardware is tightened.
I
H
G
E
F
L
N
M
K
J
O
S
Q
R
P
T
A
B
C