JobSite Systems LSC-5/5R - Manual (Page 6)

Painting the Speakers:
The speakers must be masked prior to
painting them. The inside circular portion of
the hole template can be used as a paint
mask. Remove the outside portion of the
template by gently pulling along the
perforation. Affix the mask to the front of the
speaker using a piece of tape. Fold the tape
onto itself to form a double-sided loop. Affix
the tape to the tweeter and place the mask
onto the speaker.
Painting the Grilles:
The LSC-5/5R grilles should be painted
before they are installed on the speakers.
The best results will be obtained by using a
spray gun or airless sprayer. Thin the paint,
and then apply several light coats. This
technique helps prevent clogging of grille
holes. Paint both sides of the grille to cover
all the white paint.
OPERATION
Listening at Higher Volumes:
It requires more power to achieve a
reasonable volume of sound in a large room
than it does in a small room. It is possible
to turn the volume so high that the amplifier
runs out of power. This creates “clipping”
distortion.
Clipping distortion makes treble sound very
harsh and unmusical. When you hear harsh
sounding treble from any good speaker, turn
the volume down immediately! You are
much less likely to damage a speaker with
a large amplifier because it will be very
loud indeed before it produces any
clipping distortion.
SPECIFICATIONS
LSC-5/5R
Power handing:
3 – 50 watts
Frequency response:
80Hz-20kHz +/- 4dB
Impedance:
8 ohms
Dimensions:
7-3/4” outside frame diameter
6-1/2” diameter hole cutout
2-3/4” deep when installed in 1/2” drywall
Ceiling Bracket for New Construction:
JobSite NCB-5 (sold separately)
Warranty: 5 year limited
4
DS00378ACN_LSC-5_5R.qxp 11/18/04 8:31 PM Page 4