Jasco RM25001 - Manual (Page 4)

7 6
Setup, cont. Button Functions, cont.
Battery Installation
1. On the back of the remote, push down on the tab
and lift the cover off.
2. Match the batteries to the + and - marks inside the
battery case, then insert 2 AAA alkaline batteries.
3. Press the battery cover back into place.
Battery Saver
Your remote automatically turns off if the buttons are
depressed more than 30 seconds. This will save your
batteries should your remote get stuck in a place where
the buttons remain depressed (e.g., between the sofa
cushions).
Code Saver
Codes are stored in permanent memory while you are
changing batteries so you will not lose any codes
stored in the remote while you are changing batteries.
Power-On Default
The remote powers on in TV mode.
Code Setup
The SETUP button is used to setup the remote. You can
either setup the remote using the code for your brand of
product, from the code tables (on separate sheet), or
you can search through the library of codes until you
find a code that works for your product.
Please refer to “Programming with Code Search” on page
8 for more information on using the code search feature
to learn how to search through the library of codes for
your products.
NOTE: You can store any kind of code under any mode
(except TV). I.E. you can store a VCR code under the
CBL button, or a DVD code under the VCR button, etc.
However, you can only store TV codes under the TV
button.
INPUT
When in TV mode the INPUT button performs the
INPUT source switch function.
When in a mode that has been programmed for VCR the
INPUT button performs the TV/VCR antenna switch
function.
When in a mode that has been programmed for Cable the
INPUT button performs the A.B switch function.
When in a mode that has been programmed for SAT the
INPUT button performs the TV/SAT switch function.
When in a mode that has been programmed for DVD the
INPUT button performs the DVD Setup function.
AA
A
AA
A
Setup