JVC RX-1024VBK - Manual (Page 64)

61
TV
You can always perform the following operations (with the
remote control mode selector set to “AUDIO/TV/VCR”):
TV/CATV/DBS POWER: Turns on or off the TV.
TV/VIDEO:
Sets the input mode (either TV or
VIDEO).
After pressing TV/DBS (with the remote control mode selector
set to “AUDIO/TV/VCR”), you can perform the following
operations on a TV:
CHANNEL +/–:
Changes the channels.
1 – 9, 0, 100+: Selects the channels.
RETURN: Alternates between the previously
selected channel and the current channel.
Operating JVC’s Audio/Video Components
TV/CATV/
DBS VCR 1
POWER
VCR 1 VCR 2 VIDEO
CD TAPE/MD PHONO TV/DBS
AM
MODE
SURROUND CNTR TONE CNTR – +
DIGITAL/
ANALOG
INPUT
CHANNEL – +
VOLUME – +
DISC
MUTE
+10
100+
10
FM
1
SLEEP
POWER POWER
AUDIO
2 3
TEST REAR · L
AUDIO/
TV/VCR
CATV
DBS
REAR · R
– +
4 5 6
EFFECT
SEA MODE
RETURN FM MODE/
MUTE
– +
SUBWOOFER – +
8
0
9
ENTER
MENU
MENU
SET EXIT
VCR1
/REW PLAY
TAPE
ON SCREEN CONTROL
CONTROL
LIGHT
FF/
DOWN TUNING UP
TV/VIDEO
REC
STOP PAUSE
RM-SR1024U REMOTE CONTROL
SOUND
DVD
7 /P
Note:
When you turn off the receiver
with the TV kept turned on, the
receiver will turn on soon again.
To prevent this from happening,
make sure that you turn off the
TV before turning off the
receiver.
When the TV is connected to the TV SOUND/DBS jacks on the rear:
The receiver automatically turns on and select “TV SOUND” as the source about 5
seconds after you turn on the TV. (If you change the source name from “TV
SOUND” to “DBS,” the receiver will not turn on along with the TV. See page 17)
EN56_70.RX-1024V[J]/1.PM5 98.5.12, 0:44 PM 61