Jenn-Air 730-0165 - Manual (Page 17)

Inspect the gas supply hose prior to turning on
the gas. If there is evidence of cuts, wear or
abrasion, it must be replaced prior to use. Do not
use the side burner if gas odor is present.
WARNING
Always keep your face and body as far away from
the burner as possible when lighting.
LIGHTING INSTRUCTIONS
1. Remove any cooking utensils from the burner
grate and open the top cover or lid.
2. Push and turn the control knob
counterclockwise to the “HI” setting.
3. If the burner does not light, turn the control
knob to the “OFF” position.
USING THE SIDE BURNER
4. If the smell of gas is detected and the igniter
is not functioning, immediately turn the control
knob to the “OFF” position.
5. Allow 5 minutes for any accumulated gas to
dissipate. If the side burner igniter will not
function, follow the match lighting instructions
below.
MATCH LIGHTING
1. Insert a match into the lighting rod. Ignite the
match and place near the side burner ports.
2. Turn the control knob counterclockwise to the
“HI” setting. The side burner should light
immediately.
3. Rotate the control knob to the desired setting.
CARE & MAINTENANCE OF SIDE BURNER
BURNER CLEANING
Clean the exterior of the burner with a wire
brush. Clear any clogged burner ports with a
straightened paper clip. Never enlarge the
burner ports. Never use a wooden toothpick as
it may break off and clog the port. STAINLESS STEEL
There are many stainless steel cleaners
available. Always use the mildest cleaning
procedure first, scrubbing in the direction of the
grain. Do not use steel wool, as it will scratch
the surface.
To touch up noticeable scratches in the
stainless steel, sand very lightly with dry 100
grit sand paper in the direction of the grain.
SIDE BURNER GRATE
The top burner grate is stainless steel. To avoid
burns, do not clean the grates while they are hot.
While in place, they may be washed with hot,
soapy water, rinsed and wiped dry. Never
immerse hot grates in water.
16
15