JVC SR-VS20EK - Manual (Page 42)

42
ADVANCED OPERATIONS (cont.)
Edit From
A Camcorder
You can use a camcorder as the source player and your video
recorder as the recorder.
You can perform digital dubbing if you connect a device such
as a camcorder which has a DV output/input connector.
Because the signals are digital, there is no loss of video or audio
quality as a result of editing.
MAKE CONNECTIONS
1
A If the camcorder has no S-VIDEO output connector...
... connect the camcorder’s AUDIO/VIDEO OUT
connectors to the recorder’s front panel AUDIO/
VIDEO input connectors.
B If the camcorder has an S-VIDEO output connector...
... connect the camcorder’s S-VIDEO OUT and
AUDIO OUT connectors to the recorder’s front
panel S-VIDEO and AUDIO input connectors.
A C If the camcorder has a DV OUT/IN connector...
... connect the camcorder’s DV OUT/IN connector
to the recorder’s DV IN/OUT connector.
● When using a monaural camcorder, connect its
AUDIO OUT connector to the AUDIO L input
connector on your recorder.
● When a Master Edit Control-equipped JVC camcorder
is used, the camcorder is capable of controlling the
recorder. Refer to the camcorder’s instruction manual
for operating procedure.
SELECT RECORDING DECK
2
Press VHS or DV.
SET RECORDER’S INPUT
MODE
3
Press PR on the recorder to select "F-1".
● When using the VHS deck as the recording deck, set
"VHS F-1 INPUT" to "VIDEO" for the AUDIO/VIDEO
input connectors, or "S-VIDEO" for the AUDIO/
S-VIDEO input connectors, depending on the
connectors being used (
੬ pg. 51).
SET EDIT MODE
(VHS DECK ONLY)
4
See "Picture Control" on page 37.
START CAMCORDER
5
Engage its Play mode.
START RECORDER
6
Engage its Record mode.
NOTES:
● All necessary cables can be obtained from your dealer.
● You can also use another video recorder as the player instead
of a camcorder.
● When you select EDIT to dub tapes in step 4, be sure to select
AUTO (or NORM when B.E.S.T. is set to OFF) after you finish
dubbing the tapes.
● When you are editing through the DV IN/OUT connector, the
recorder will stop if the player begins playing a blank portion
of tape or the signal is interrupted.
● To use the DV deck as the recording deck with connection
A or B
In step 3, after selecting "F-1"
, press ← and then press DV to
select the DV deck. Then follow the procedures from step 5.
To use the VHS deck as the recording deck with connection
C
In step 3, after selecting "F-1"
, press → and then press VHS to
select the VHS deck. Then follow the procedures from step 4.
VHS
DV
PR