JVC 1000MKV*UN*VP - Manual (Page 44)

44
EN
I T E M S N O T E S
❍ Perform charging where the temperature is between 10° and 35°C. 20° to
25 °C is the ideal temperature range for charging. If the environment is too
cold, charging may be incomplete.
❍ Charging times noted above are for a fully discharged battery pack.
❍ Charging time varies according to the ambient temperature and the status of
the battery pack.
❍ To avoid interference with reception, do not use the AC Adapter near a
radio.
❍ Since the AC Adapter processes electricity internally, it becomes warm
during use. Be sure to use it only in well-ventilated areas.
❍ The following operation stops charging or discharing:
•Set the Power Switch to “ ”, “ ” or “ ”.
•Disconnect the AC adapter from the camcorder.
•Unplug the AC adapter’s power cord from the AC outlet.
•Detach the battery from the camcorder.
❍ The date/time cannot be stored in memory if the built-in clock battery runs
out. Consult an authorized JVC dealer for replacement, or set the date/time
as necessary before you start shooting.
❍ When the Power Switch is set to “ ” or “ ” and the LCD monitor is
opened at an angle of 60 degrees or more, the LCD monitor switches on
and the viewfinder switches off automatically to save power.
❍ The cassette holder cannot be opened unless a power supply is attached.
❍ There may be a delay after you slide EJECT until the cassette holder opens.
Do not use force.
❍ The time required to calculate the remaining tape length, and the accuracy
of the calculation, may vary according to the type of tape used.
❍ The tape remaining time indicator is correct only if the correct tape length
has been selected ( ੬ pg. 12).
❍ “TAPE END” appears when the tape reaches its end, and the power goes off
automatically if left in this condition for 5 minutes.
“TAPE END” also appears when a cassette whose tape is already at its end
is loaded.
❍ If the Recording Start/Stop button is pressed after the Record-Standby mode
has continued for over 5 minutes, recording may not start immediately.
❍ While shooting, sound is not heard from the speaker.
❍ The “TBC” indicator turns green (grey with a camcorder equipped with a
black/white viewfinder) while TBC is working.
❍ TBC does not work during still playback and shuttle search.
❍ The “TBC” indicator turns white while TBC is not operative.
❍ It may take a few seconds before TBC actually starts working.
❍ The picture may be distorted if the TBC mode is activated or deactivated at
the edit-in/-out points or when normal playback resumes after still playback
or shuttle search.
❍ If the playback picture is distorted when TBC is set to on, turn off TBC.
DETAILS
➪
Date/Time
Settings
(
੬
pg. 9)
➪
Power
(
੬
pg. 6)
➪
TBC
(Time Base
Corrector)
(
੬
pg. 31)
➪
Recording
(
੬
pg. 14, 15)