Jensen JiMS-120 - Manual (Page 9)

AUX Mode
When you are using an iPod without a docking port or other MP3 / digital audio player, you can still
play it on the JiMS-120 via the AUX IN jack.
- Power on the unit.
- Press “FUNCTION” button until “AUX” icon appears in the display.
- Connect the portable audio device using the 3.5mm audio cable (provided) to the AUX IN jack at
the back panel of the unit.
- Turn on the external audio player and starts playing. You may need to adjust your player / audio
volume if it is connected via the headphone jack of your audio device.
- Adjust the volume by “+” or “-“button.
BASS BOOST Operation
- Press “BB” button to turn on / off bass boost effect.
Note: Bass boost effect is available in all function modes. It can be switched ON/OFF by remote BB button.
To use the remote control, please ensure the remote control battery CR2025 (included) is installed
properly.
Replace the remote control battery when it stops working. It is highly recommended to use a good
quality DC3V Lithium cell.
- POWER ON/OFF button: Press to switch on or off your unit.
- MUTE button Press to cut off the output sound immediately.
- PLAY/PAUSE button: Start/pause the music playback. Press and hold to stop your iPod and return it to sleep mode.
- SKIP ( and ) buttons: Press to change to your favorite song. Press and hold to search the desired music
passage.
- SLEEP button: Press to set the sleep timer.
- Radio Memory Channel button +/- buttons: Press to select your saved radio memory channel.
- Bass Boost button: Press to switch Bass Boost effect ON/OFF.
- Volume +/- buttons: To adjust the volume to desired level.
- FUNCTION button: Press to select the function mode.
- SNOOZE button: Press to suspend sounding alarm sound for 10 minutes.
Note:
- Room lighting and battery life can affect the operating range of the remote control.
- To ensure the Infrared remote control works as expected, your iPod must have the proper or latest iPod
software installed.
- The remote control works even when the iPod is locked.
REMOTE CONTROL
SETUP AND OPERATIONS
8
CARE AND MAINTENANCE
- Do not subject the unit to excessive force, shock, dust or extreme temperature.
- Do not tamper the internal components of the unit.
- Clean the unit with a damp (never wet) cloth except metal contact or speaker grille. Solvent or -
detergent should never be used.
- Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
- Keep your unit away from heating appliances and sources of electrical noise such as fluorescent
lamps or motors.
- Always keep your finger dry and clean before touching all the buttons.
- Do not dispose of batteries in fire, batteries may explode or leak.
Note:
1.
2.
3.
When using the alarm wake to AUX mode, please set your iPod shuffle or AUX source (e.g. MP3, CD player & etc.)
to REPEAT ALL mode after turning off the unit.
If you want to wake to a specific song, please select it on your iPod shuffle or external Player and select REPEAT
ONE mode instead.
When selecting the AUX as the wake to setting and using a battery-powered external player as the source, you will
need to make sure there is sufficient power to run the player beyond the desired wake-up/alarm time. We strongly
recommend using an AC adaptor wherever possible.
the