Jenn-Air JTO500 - Manual (Page 13)

Changing The Accent Base
Before Changing the Accent Base
Make sure that the toaster is completely turned off. The START/STOP button should
not be illuminated. Unplug the power cord from the wall outlet and remove the cord
from the toaster; set aside. Remember that the toaster and crumb tray will be hot
immediately following a toasting cycle. Always allow the toaster to cool before cleaning or
changing the accent base. It is recommended that the crumb tray be emptied after each
use and before performing this operation.
How to Change the Accent Base
1. Empty the crumb tray and reinsert. Place a soft
hand towel on a solid, level surface. Place the toast-
er on its top, slots facing down on the towel. (Note:
A few residual crumbs may fall from the slots.)
2. Locate the four rubber feet on the underside of
the toaster.
3. Loosen each of the feet by turning counter-
clockwise by hand.When all four feet are
completely removed, lift off the accent base and
carefully set aside.
4. Position the new accent base on the toaster body
and secure it to the toaster by re-installing the four
feet.Turn the feet clockwise and tighten each by
hand until snug.
NOTE: The feet are designed to be tightened by hand
only. DO NOT ATTEMPT TO OVERTIGHTEN USING
TOOLS. Attempting to do so can damage
the feet.
5. Position the toaster right side up on the countertop resting on its feet. Set the
hand towel aside. Reinsert the detachable power cord.
Injury Hazard – Unplug toaster before performing this operation. Failure to do so
can result in injury
12
WARNING