JVC DD868EU - Manual (Page 17)

EN
17
Soundtrack Selection
Your video recorder is capable of recording three soundtracks (HI-FI L, HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing AUDIO on the remote control changes the soundtrack being played back as follows:
TRACK
Recorder's Front Panel On-Screen Display
USE
+
HI FI
For Hi-Fi stereo tapes
L R
HI FI
For main audio of Bilingual tapes
L
HI FI
For sub audio of Bilingual tapes
R
NORM NORM For audio-dubbed tapes
+ + NORM
HI FI
For audio-dubbed tapes
NORM
NOTES:
● " + " should normally be selected.
In this mode, Hi-Fi stereo tapes are
played back in stereo, and the normal
audio track is played back
automatically for tapes with only
normal audio.
● For instructions on recording stereo
and bilingual programmes, refer to
page 23.
● "O.S.D." must be set to "ON" or the
on-screen displays will not appear
(
੬
pg. 9).
Repeat Playback
Your video recorder can automatically play back the whole tape
50 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
● The Play indicator ( ) on the display panel blinks
slowly.
● The tape plays 50 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.
Instant ReView
Simply by pressing a single button, the recorder power comes
on, rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTE:
Before starting, make sure that the recorder is off and that the
Timer mode is disengaged.
ACTIVATE INSTANT
REVIEW
1
Press REVIEW. The recorder power comes on and the
recorder searches for the index code indicating the start
of the last timer-recorded programme. Once it’s found,
playback begins automatically.
● The front display panel tells you how many programmes
have been timer-recorded. If you have, for example, 3
programmes, “REVIEW” and "3" appear and blink. To
watch the first of the 3 programmes, press REVIEW three
times. The recorder searches and begins playback
automatically. You can access a programme as far as 9
index codes away from the current tape position.
NOTES:
● Instant ReView is not possible while the recorder is in the
Timer mode.
● The number of recorded programmes will not be displayed on
the front display panel after Auto Satellite Prog recording
(
੬
pg. 32).