Jensen JiMS-210 - Manual (Page 10)

8
RADIO OPERATIONS
FM Antenna
Unwrap and fully extend the FM Antenna wire for best FM radio reception.
Radio Tuning
1. Press the POWER On/Off button to turn on the unit.
2. Slide the FUNCTION (#4) switch to select Radio mode.
3. Slide the BAND (#5) switch to select AM or FM radio band.
4. Rotate the TUNING (#6) knob and tune to a desired radio station.
5. Adjust the sound level by turning the VOLUME (#7) wheel.
from the dock to improve AM
reception.
NOTE: The iPod may cause interference to the AM reception if it is docked and turned ON.
You should turn off the iPod manually or remove it
Tips for the Best Reception
To obtain the best AM reception, slightly rotate the unit until the clearest signal is received or place
it near outdoor.
To obtain the best FM reception, fully extend the FM Antenna and adjust its direction.
iPod DOCKING
If the docking port will not be used for an extended period of time, it is recommended to cover the
docking port by using the “Dock Cover” insert (included).
1. Use the iPod adaptor included in your iPod and insert it into the docking area. Your iPod can now be
inserted into the docking port by placing the connector on the bottom of the iPod onto the connector in
the docking bay.
Note: - Please be careful when seating the iPod into the docking to avoid damaging the 30-pin connector
on the iPod or in the docking system.
2. Press the POWER On/Off button to turn on the unit.
3. Slide the FUNCTION switch to select iPod mode. The iPod will start playing automatically and start
charging immediately.
4. Press the PLAY / PAUSE button to pause or resume iPod playback.
5. Adjust the sound level by turning the VOLUME wheel (#7).
Note : The volume level cannot be adjusted using the volume control on
your iPod after being docked.
6. The iPod charges even during playback.
Note : The iPod will only charge in iPod or AUX modes.
7. To remove the iPod from the unit, press and hold the PLAY/PAUSE button for three seconds to switch
off the device and then gently remove it from the docking connector.
iPod playback control:
- Press the PLAY/PAUSE button to pause or resume the iPod playback;
- Press the iPod Skip/Search Forward or Backward button to skip to the next or previous song;
- Press and hold the iPod Skip/Search Forward or Backward button for fast-forwarding or
fast-rewinding during playback.