JVC GET0087-001A - Manual (Page 34)

ENGLISH
34
To tune in to a particular ensemble
without searching:
1 Press and hold DAB (FM AM) to select DAB
tuner as the source.
2 Press DAB (FM AM) repeatedly to select the
DAB band (DAB1, DAB2 or DAB3).
3 Press and hold ¢ or 4 for more
than 1 second.
4 Press ¢ or 4 repeatedly until the
ensemble you want is selected.
• If you hold down the button, the frequency
keeps changing until you release the button.
To restore the FM AM tuner
Press and hold DAB (FM AM) again.
Storing DAB services in
memory
You can preset up to 6 DAB services in each
DAB band (DAB1, DAB2 and DAB3) manually.
1
Select the DAB tuner.
Each time you press and
hold the button, the DAB
tuner and the FM AM tuner
are alternately selected.
2
Select the DAB band (DAB1, DAB2
or DAB3) you want.
Each time you press the
button, the DAB band
changes as follows:
3
Start searching an ensemble.
When an ensemble is received, searching
stops.
To stop searching before an ensemble is
received, press the same button you have
pressed for searching.
4
Select a service you want to listen to.
To change the display information while
tuning in to an ensemble
Normally service name is shown on the display.
If you want to change the display information,
press DISP (display).
Each time you press the button, the
following information appears on the
display for a while.
Press ¢ to search
ensembles of higher
frequencies.
Press 4 to search
ensembles of lower
frequencies.
Press 5 (up) to select the
next service.
Press ∞ (down) to select
the previous service.
Ensemble name
Service name
Channel number
Frequency
DAB1 DAB2 DAB3
(D1) (D2) (D3)
FM/AM DAB
EN33-36KD-SX927R[EE]f.pm5 14/02/2002, 10:19 AM 34