JVC GET0087-001A - Manual (Page 9)

9
ENGLISH
Searching a station manually:
Manual search
1
Select the band (FM1 – 3, AM).
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to an
FM broadcast.
2
Press and hold ¢ or 4 until
“MANU” (manual) starts flashing on
the display.
3
Tune in to a station you want while
“MANU” is flashing.
Selected band appears.
Press ¢ to tune
in to stations of higher
frequencies.
Press 4 to tune
in to stations of lower
frequencies.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing—in 50 kHz intervals
(87.5 MHz – 108 MHz for FM 1 and FM 2),
in 30 kHz intervals (65 MHz – 74 MHz for FM
3) and 9 kHz for AM – MW/LW until you
release the button.
When an FM stereo broadcast is hard to
receive:
1 Press MODE to enter the functions
mode while listening to an FM
stereo broadcast.
“MODE” appears on the lower part
of the display, and the number
buttons work as different function
buttons.
2 Press MO (monaural), while
“MODE” is still on the display, so
that the MO indicator lights up on
the display.
Then, each time you press MO
(monaural), the MO indicator lights
up and goes off alternately.
FM1 FM2 FM3 AM
(F1) (F2) (F3)
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved (the ST indicator
goes off).
Lights up when receiving an FM broadcast in stereo.
EN08-11KD-SX927R[EE]f.pm5 14/02/2002, 10:15 AM 9