JVC MX-D302T - Manual (Page 27)

25
8. Press the 8 SET button.
The volume level blinks on the display.
9. Press the SELECT 5 + or 4 – button
to set the volume level.
10. Press the 8 SET button.
The display returns to the display before you set the timer.
Before Turning the Unit Off
• Check that the selected source is ready.
• If you will be recording a source while you are out, set the volume to 0.
To turn the Timer off, press the 2 TIMER button after pressing the SHIFT button. The Timer indicator
on the display goes out.
Setting the Sleep Timer
Use the Sleep Timer to turn the Unit off after a certain number of minutes when it is playing. By setting
this timer, you can fall asleep to music and know your Unit will turn off by itself rather than play all
night.
o
You can only set the Sleep Timer when the Unit is on and a source is playing.
To set the Sleep Timer, follow this procedure:
1. With the System on and a source
playing, press the SLEEP button
on the Remote Control.
2. Set the length of time you want the source to play before shutting
off.
• Each time you press this button,the number of minutes shown on the display changes as follows:
= 10 = 20 = 30 = 60 = 90 = 120 = Canceled = (back to the beginning)
When the number of minutes you want are shown on the display, just wait 5 seconds until the number of
minutes stops blinking and remains lit.
The Unit is now set to turn off after the number of minutes you set.
To Change the Sleep Timer Setting
Press the SLEEP button until the number of minutes you want appears on the display.
To Cancel the Sleep Timer Setting
Press the SLEEP button until the SLEEP indicator goes off on the display.
Turning off the Unit also cancels the Sleep Timer.
8
SET
4 5
– SELECT +
8
SET
SLEEP
A.BASS EX S.MODE
SLEEP
EN.MX-D302T[J]/f 98.1.13, 5:06 PM 25