JVC MX-D302T - Manual (Page 7)

5
CAUTION: Make all connections before plugging the Unit into an AC power outlet.
Connecting the Speakers
For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the System.
1. Open each of the terminals and insert the speaker wires firmly, then close the terminals.
2. Connect the red (+) and black (–) terminals of the right side speaker to the red (+) and black (–)
terminals marked RIGHT on the System.
Connect the red (+) and black (–) terminals of the left side speaker to the red (+) and black (–)
terminals marked LEFT on the System.
Now you can plug the AC power cord into the wall outlet, and your System is
at your command!
RIGHT LEFT
AUX
VCR or other equipment
To listen to this source, press the AUX
button.
IMPORTANT: Use speakers with the correct impedance only.
The correct impedance is indicated on the back panel.
CAUTION: If a TV is installed near speakers, the TV may display
irregular colors. In this case, set the speakers away from the TV.
Connecting Auxiliary Equipment
Right Speaker Left Speaker
Laying Out the Unit
Leave a space of at least 1 cm on
both sides of the Unit and at least
10 cm at the back, for ventilation.
1 cm (7/16”) 1 cm (7/16”)
DISC
DISC
DISC
REPEAT
RANDOM
CONTINUE
EN.MX-D302T[J]/f 98.1.13, 5:05 PM 5