JVC VN-V25U - Manual (Page 27)

27
6.
The top page of VN-V25U appears
7.
The [Basic] page with the IP address settings appears when DHCP is not in use
A confirmation screen appears. Press the [OK] button. VN-V25U restarts using the new IP address. It
takes about one minute for the camera to reboot.
Note:
● Access from this computer may fail when the IP address of VN-V25U is changed. To enable access
to VN-V25U from the same computer, alter the IP address at the computer accordingly.
● If GUI is strange, please check [DPI setting] as below.
Open the [Display Properties] at [Start]-[Control Panel]-[Display].
Click the [Settings] of [Display Properties] and [Advanced...] button.
Check [Normal Setting (96DPI)] is selected in [DPI setting]. If not, select it and restart the PC.
Click on [Network], followed by [Basic]
on the next submenu.
A
B
C
Enter the values you wish to specify in
the [IP Address], [Subnet Mask] and
[Default Gateway] fields.
Click [OK].
Set the [IP Setting] item to [DHCP
Disable].
VN-V25U_EN.book Page 27 Friday, November 9, 2007 10:30 AM