Jensen JiSS-585 - Manual (Page 3)

WARNING
Do not throw the product into fire to avoid danger of explosion.
Do not immerse into water or get soaked since the battery charging function will be lost.
Place the product far away from heat sources, and protect the product from direct
sunlight.
Do not use the product where electric appliances are prohibited.
Protect the product from violent impact and vibrations.
No compensation responsibility for malfunctions caused by improper use.
Do not attempt to disassemble or alter any part of the unit that is not expressly described
in this guide. Internal inspections, alternations and repairs should be conducted by
qualified service personnel.
IMPORTANT SAFETY INSTRUCTIONS
When used in the directed manner, this unit has been designed and manufactured to ensure your
personal safety. However, improper use can result in potential electrical shock or fire hazards. Please
read all safety and operating instructions carefully before installation and use, and keep these
instructions handy for future reference. Take special note of all warnings listed in these instructions and
on the unit.
1. Water and Moisture
The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink,
laundry tub, swimming pool or in a set basement.
2. Ventilation
This unit should be situated so that its location or position does not interfere with its proper
ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may
block the ventilation openings. Also, it should not be placed in a built-in installation, such as a
bookcase or cabinet, which may impede the flow of air through the ventilation openings.
3. Heat
The unit should be situated away from heat sources such as radiators, heat registers, stoves or other
appliances (including amplifiers) that produce heat.
4. Power Source
The unit should be connected to a power supply only of the type described in the operating
instructions or as marked on the appliance.
5. Power Cord Protection
Power supply cords should be routed so that they are not likely to be walked on or pinched by items
placed upon or against them. It is always best to have a clear area from where the cord exits the unit
to where it is plugged into a DC outlet.
2