John Lewis JLBIFF 1802 - Manual (Page 12)

9
Fit the appliance in the niche by making sure that it
stands against the interior surface of the unit on the
side where the door hinges of the appliances are
fitted. Insert the appliance until the upper strip butts
up against the unit (1) and make sure that the lower
hinge is in line with the surface of the unit (2).
D023
1
2
D724
Apply the sealing strip pushing it between the
refrigerator and the adjacent cabinet.
I
P
Fasten the appliance with 4 screws provided in the
kit included with the appliance.
(I = short) (P = long)
Apply covers (C-D) on joint cover lugs and into
hinge holes.
Snap vent grille (B) and hinge cover (E) into
position.
PR266
Ha Hb
Hc
Hd
Separate parts Ha, Hb, Hc, Hd as shown in the
figure.
B
E
C
D
12
Push button
A - ON/OFF light - Green
B - Thermostat control knob
C - Quick freeze light - Amber
D - Quick freeze switch
A. Pilot light
The operation light is illuminated continuously, to
show that the appliance is on.
B.Thermostat control knob
Turn the thermostat control knob clockwise to
required setting.
C. Quick freeze light
The quick freeze light is illuminated, to show that
the quick freeze function is working.
D. Quick freeze control switch
When you place fresh food in the appliance, press
the quick freeze control switch.
When the Fridge Freezer is
first installed
Warning
Allow the appliance to stand for 2 hours after
installation.
Insert the plug into the wall socket.The pilot light
(A) will illuminate to show that the appliance is on.
Turn the thermostat control (B) to a midway setting.
Leave the appliance for approximately 4 hours for
the correct temperature to be reached before
placing food inside.
To switch off the appliance turn the thermostat
control to position “
● ” .
B A C D
Temperature control
The temperature within the freezer is controlled by
the thermostat situated in the middle of the
appliance.
To operate the freezer proceed as follows:
Position 1 = minimum coldness
Position 6 = maximum coldness
Turn the thermostat control knob beyond the « ● »
position.
When you first start the freezer, we suggest that
you turn the thermostat control to a medium
setting. For easier turning of this control, use a small
coin.The internal temperature of the freezer is
automatically adjusted by the thermostat to ensure
safe food storage.
However, if the appliance is working in unfavourable
room conditions such as
- poor ventilation,
- high temperature,
- frequent door openings,
it may be necessary to select a more suitable
setting.
The Control Panel