John Lewis JLBIFF 1802 - Manual (Page 15)

6
Installation
Electrical connection
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
WARNING:THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability should this
safety measure not be observed.
If the plug that is fitted to your appliance is not suitable
for your socket outlet, it must be cut off and the
appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to prevent
the hazard of shocks in case it should be plugged into a
13amp socket in another part of your home.
Important
The wires in the mains lead are coloured in accordance
with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If you fit your own plug, the colours of the wires in the
mains lead of your appliance may not correspond with
the markings identifying the terminals in your plug,
proceed as follows:
1. Connect the Green and Yellow (earth) wire to the
terminal in the plug which is marked with the letter
«E» or the earth symbol or coloured green and
yellow.
2. Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter «N» or coloured
black.
3. Connect the brown (live) wire to the terminal in the
plug which is marked with the letter «L» or coloured
red.
4. Upon completion there must be no cut, or stray
strands of wire present and the cord clamp must be
secure over the outer sheath.The plug moulded onto
the lead incorporates a fuse. For replacement, use a
13amp BSI362 fuse. Only ASTA or BSI approved fuses
should be used.
The plug must not be used if the fuse cover/carrier is
lost.The cover/carrier is indicated by the coloured insert
at the base of the plug.
A replacement cover/carrier must be obtained from your
local Service Force Centre.
D207
GREEN & YELLOW
13 AMP. FUSE
BROWN
CORD CLAMP
BLUE
13
AMP
Technical Data
Dimensions of recess
Height 1780 mm
Width 560 mm
Depth 550 mm
Dimensions of the appliance cavity
Height 1772 mm
Width 540 mm
Depth 547 mm
Fridge Gross capacity 214 litres
Fridge Net capacity 210 litres
Freezer Gross capacity 68 litres
Freezer Net capacity 55 litres
Heating elements rating
Supply voltage (50 Hz) 220-240 V
Connected load, 160 W
Fridge light 15 W
It is dangerous to alter the specifications or
attempt to modify this product in any way.
Care must be taken to ensure that the
appliance does not stand on the electrical
supply cable.
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
15
P R X X X
PR271
Bottle holder
Place the bottles (with the opening facing front) in
the pre-positioned shelf.
If the shelf is positioned horizontally, place only
closed bottles.
This bottle holder shelf can be tilted in order to
store previously opened bottles.
To obtain this result, pull the shelf up so it can
rotate upwards and be placed on the next higher
level.
Humidity control
The glass shelf incorporates a device with slits
(adjustable by means of a sliding lever), which makes
it possible to regulate the temperature in the
vegetable drawer(s).
Close the slots to obtain a warmer temperature and
greater humidity.
Open the slots to obtain a cooler temperature and
less humidity.
Positioning the door shelves
To permit storage of food packages of various sizes,
the door shelves can be adjusted in height.To make
these adjustments proceed as follows:
Gradually pull the shelf in the direction of the
arrows until it comes off, then reposition as
required.
Air recycling
The refrigerator compartment is equipped with a
special D.A.C.(Dynamic Air Cooling) fan which can
be turned on with the switch (fig. 1). The green light,
when on, means that the fan is working.
It is suggested that the fan (D.A.C.) be used when
the ambient temperature exceeds 25°C .
This device allows for rapid cooling of foods and a
more uniform temperature in the compartment.
SWITCH
Fig. 1