JVC HR-DD740U - Manual (Page 26)

26
EN
3
¶
4 ¢
7 8
1 ¡
1 2 3
4 5 6
7 8
0
9
q
¢ ¢
2 2
Manual Tracking
Once playback begins, the VCR’s automatic tracking function is
engaged. If noise appears in the picture, you can override this
and make the adjustment manually.
PLAYBACK AND RECORDING FEATURES (cont.)
ENGAGE MANUAL
TRACKING MODE
1
During playback, press the CH 5 and ∞ buttons on the
VCR's front panel simultaneously to cancel the
automatic tracking mode and enable manual tracking
adjust.
ADJUST MANUAL
TRACKING
2
Press CH 5 or ∞ on the VCR's front panel or remote.
Press briefly for fine adjust, or press and hold for coarse
adjust. Watch the screen and continue adjusting until
optimum picture and sound quality are achieved.
RE-ENGAGE AUTOMATIC
TRACKING
3
Press the CH 5 and ∞ buttons on the VCR's front panel
simultaneously.
● When automatic tracking is re-engaged, Auto Picture
is automatically activated.
NOTES:
● To obtain a noiseless still picture it may be necessary to adjust
tracking in slow playback and then engage Pause.
● Manual tracking is possible during hands-free slow-motion.
During hands-free slow-motion playback, simply press
CH 5
or ∞ on the VCR's front panel or remote to adjust tracking.
Tape Position Indicator
The Tape position indicator appears
on screen when, from the stop
mode, you press FF, REW, or
perform an Index Search or Instant
ReView. The position of " " in
relation to "B" (Beginning) or "E"
(End) shows you where you are on
the tape.
NOTES:
● "SUPERIMPOSE" must be set to "ON", or the indicator will not
appear (
੬
pg. 28).
● It may take a few seconds for the Tape Position Indicator to be
displayed.
COUNT 0:33:27
B E + + +
CH FF REW
REW
FF
CH