JVC HR-DD740U - Manual (Page 54)

54
EN
3
¶
4 ¢
7 8
1 ¡
1 2 3
4 5 6
7 8
0
9
POWER
A/B
NUMBER "1"
NUMBER "2"
UNPLUG VCR'S POWER
CORD
1
Unplug from the AC outlet.
SET REMOTE CONTROL
CODE
2
While holding down A/B on the remote control, press
the NUMBER key "2" and then press STOP.
PLUG IN POWER CORD
3
Plug back in to the AC outlet.
TURN VCR POWER ON
4
Press POWER on the remote.
The VCR will now respond only to B-code commands.
To set the VCR to respond to A code signals again, repeat the
above procedures setting the A/B CODE switch to A, instead of
B, in step 2.
You can control two VCRs with the same remote control by
switching the remote's code between A and B.
Control Two JVC VCRs
The remote control is capable of controlling two JVC VCRs
independently; one set to respond to your remote control's A
code control signals and another set to respond to B code
control signals. The remote control is preset to send A code
signals because your VCR is initially set to respond to A code
signals. You can easily modify your VCR to respond to B code
signals.
STOP
SPECIAL FEATURES (cont.)