JVC DT-V17L2D - Manual (Page 6)

ENGLISH
Hook and screws (M4 x 10 mm)
(not provided)
Hook (not provided)
5
To adjust the stand height
Screw holes for higher position Screw holes for lower position
Stand plate
Stand plate
Stand body
You can select the stand height—higher position or lower position.
To change the stand height, change the position of the stand plate as illustrated below after detaching the stand
from the monitor.
• For detaching the stand, see “To detach the stand” on page 4.
Stand body
<Higher position> <Lower position>
To prevent an accidental fall
Fix the monitor to a wall by using strings.
Fixing the monitor
Attach the hook (not provided) to the VESA mounting holes on the rear panel (use the two holes on the upper
side) using M4 x 10 mm screws (not provided). Bind the hooks on the rear panel of the monitor to a wall or a pillar
using durable string.
DT-V17L2D_EA_EN_R.indd 5 DT-V17L2D_EA_EN_R.indd 5 07.9.14 7:01:42 PM 07.9.14 7:01:42 PM