JVC GD V502U - Manual (Page 18)

18
Selecting the On-Screen Menu Language
Select the Input Signal
Input signals will change as follows:
press to display the SET UP menu.
press to select your preferred language.
Selectable languages
ENGLISH(UK)
Deutsch
Français
Italiano
Español
ENGLISH(US)
.......(Chinese)
press to select OSD LANGUAGE.
Notes:
(1) Input terminal will not be selected if the terminal board is not installed
into the SLOT.
(2) Select to match the signals from the source connected to the
component/RGB input terminals. (see page 33)
(3) In 2 screen display, the same input mode cannot be selected for
the main picture and sub picture.
Input Signal Selection
Press the INPUT button to select the input signal
to be played back from the equipment which has
been connected to the Plasma Display.
R - STANDBY G POWER ON INPUT MENU ENTER — + VOL
MENU ENTER
— + VOL INPUT
SURROUND
VOL
N R
INPUT
INPUT
SET UP 1/2
SIGNAL
SCREENSAVER
INPUT LABEL
COMPONENT/RGB-IN SELECT
RGB
RGB1
OSD LANGUAGE ENGLISH ( US )
POWER SAVE OFF
STANDBY SAVE ON
POWER MANAGEMENT OFF
INPUT
SURROUND
VOL
N
PICTURE SOUND
R
SET UP
SET UP
PC IN INPUT1 INPUT2 INPUT3