JVC GD V502U - Manual (Page 30)

30
Press to select “ON” or “OFF”.
Press to select
“POWER SAVE”
“STANDBY SAVE”
“POWER MANAGEMENT”
“AUTO POWER OFF”.
Reduces power consumption
Press to exit from SETUP.
Press to select INPUT LABEL.
Press to change the INPUT LABEL.
Customizing the Input labels
This function can change the label of the Input signal to be displayed.
Notes:
While selecting a Input signal through Optional Terminal Board connected to Slot 1 to Slot 3, the Input label will depend
on each Optional Terminal Board.
INPUT LABELS for Slot 1 to Slot 3 and miniD-sub:
[Slot1 Input] INPUT1/VIDEO1/COMPONENT1/RGB1/RGB1(digital)/PC1/DVD1/CATV1/VCR1/STB1
[Slot2 Input] INPUT2/VIDEO2/COMPONENT2/RGB2/RGB2(digital)/PC2/DVD2/CATV2/VCR2/STB2
[Slot3 Input] INPUT3/VIDEO3/COMPONENT3/RGB3/PC3/DVD3/CATV3/VCR3/STB3
[PC (MiniD-sub) input] PC/COMPONENT/RGB/DVD/STB
Note:
“POWER MANAGEMENT” and “AUTO POWER OFF” are effective during normal viewing (one picture screen) only.
SET UP 1/2
SIGNAL
SCREENSAVER
INPUT LABEL
COMPONENT/RGB-IN SELECT
RGB
RGB1
OSD LANGUAGE ENGLISH ( US )
POWER SAVE OFF
STANDBY SAVE ON
POWER MANAGEMENT OFF
SET UP 2/2
AUTO POWER OFF OFF
MULTI DISPLAY SETUP
SET UP TIMER
PRESENT TIME SETUP
SET UP 1/2
SIGNAL
SCREENSAVER
INPUT LABEL
COMPONENT/RGB-IN SELECT
RGB
RGB1
OSD LANGUAGE ENGLISH ( US )
POWER SAVE OFF
STANDBY SAVE ON
POWER MANAGEMENT OFF
ON OFF
SET UP
• POWER SAVE:
• STANDBY SAVE:
• POWER MANAGEMENT:
• AUTO POWER OFF:
When this function is turned ON, luminous level of the plasma display is suppressed, so
power consumption is reduced.
When this function is turned ON, power consumption of the microcomputer is reduced
during power supply standby (see page 13,14,15), so standby power of the set is reduced.
The unit power supply is turned ON or OFF depending on whether or not there is a signal
during PC input mode.
This function is enabled when it is turned ON. (Only during input from PC(Mini D-sub)
terminal)
Equipment power supply is turned OFF when there is no signal.
When this is set to On, the power supply of the unit goes Off 10 minutes after the input
signals stop.
This function is effective for input signals except input from PC (Mini D-sub) terminal.