JVC HR-XVC39SU - Manual (Page 33)

Symptom Cause Correction
The DVD+VCR does not
start playback. No disc is inserted.
No tape is inserted. •
• Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.) •
An unplayable disc is inserted. • Insert a playable disc. (Check the
disc type and Regional code.) •
The disc is placed upside down. • Place the disc with the playback side
down. •
The disc is not placed within the
guide. • Place the disc on the disc tray cor-
rectly inside the guide. •
The disc is dirty. • Clean the disc. •
Video tape cannot be
inserted. Is the cassette compartment empty? • Eject the tape in. •
No Hi-Fi sound Audio mode is not set properly. • Select STEREO by repeatedly
pressing A.MONITOR on the remote
control. •
The remote control does
not work properly. There is an obstacle in the path of
the remote control and this unit. • Remove the obstacle. •
The batteries in the remote control
are exhausted. • Replace the batteries with new ones. •
The remote control is not pointed at
the remote sensor of the DVD+VCR. • Point the remote control at the
remote sensor of the DVD+VCR. •
The remote control is too far from the
DVD+VCR. • Operate the remote control within
23 ft (7m). •
This remote control use the same
buttons for VCR and DVD functions
(ex. PLAY). • When using a VCR, first press the
VCR button. When using a DVD, first
press the DVD button. •
Camcorder image is not
shown. Camcorder is off. • Turn camcorder on and operate
properly. •
Camcorder image via AV
input to DVD+VCR is not
shown on TV screen. DVD+VCR SOURCE SELECT is not
set to LINE1 or LINE2. • Press AUX to select LINE input
channel (LINE1 or LINE2). •
Timer recording is not
possible. Clock in DVD+VCR is not set to cor-
rect time. • Set clock to correct time. •
Timer has been programmed incor-
rectly. • Reprogram Timer. •
indicator light does not appear
after programming timer.
• Reprogram Timer and turn
DVD+VCR off to enable timer. •
33
Ref
erence