JVC DLA FS-X3 - Manual (Page 20)

18
Using External Equipments
Listening to External
Equipment
You can listen to the external equipment such as MD re-
corder, tape deck or other auxiliary.
❑ First make sure that the external equipment is properly
connected to the System. (See page 8).
1 Set the VOLUME control to the mini-
mum position.
2 Press the LINE button on the Remote
Control.
“LINE” will appear on the display.
• You can also select “LINE” using the Source selector
on the Unit.
3 Start playing the external equipment.
4 Adjust the VOLUME control to the
desired listening level.
5 Apply the following sound effects, if you
wish.
• AHB PRO (See page 10.)
• Tone (BASS/TREBLE) (See page 11.)
To exit the source “LINE”, select other source (e.g.
CD).
• For operation of the external equipment, refer to its In-
structions.
Changing the Equipment’s Name
You can change the equipment’s name according to the
equipment to be used. (At purchase, “LINE” is selected.)
On the Remote Control
1 Press the LINE button to select the
source “LINE”.
2 Press the LINE button for two seconds
or more.
“NAME CHANGE” blinks on the display.
3 While “NAME CHANGE” is blinking,
press the SET button.
4 Press the
3
or
2
button repeatedly to
select the desired name.
Each time you press the button, the equipment name
changes as follows.
LINE
Ô TAPE Ô DBS Ô VCR Ô TVÔ
GAME Ô (back to the beginning)
DBS (Direct Broadcasting Satellite): For CS/BS
5 Press the SET button
The current name is replaced with new one.
(When TAPE is selected)
• The selected name will appear on the display when you
select the source “LINE”.
Source
selector
SET
2 3
LINE
FS-X3(A)_E.book Page 18 Friday, March 28, 2003 2:57 PM