Smeg DWD409WH - Manual (Page 11)

User instructions
39
END PROGRAM
When the program finishes, a buzzer sounds
briefly and all the PROGRAM PHASES lights
(7) flash.
Press any of the SELECTION PROGRAMS buttons (2), stops the light
flashins, and the dishwasher is now ready to perform a new cycle;
opening and shutting the door or switching the appliance off and on has
the same effect.
INTERRUPTION OF A PROGRAM
In order to interrupt a running program it is necessary:
• press one of the SELECTION PROGRAMS buttons (2), the light of
the current phase will go out;
• keep the button pressed until the PROGRAM PHASES lights (7)
come on (confirmation buzzer);
• start the program (see “S
TART PROGRAM ”).
TO CHANGE A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see “I
NTERRUPTION OF A PROGRAM ”);
• select the new program;
• start the new program (see “S TART PROGRAM ”).
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
“I
NTERRUPTION OF A PROGRAM ”).
Now press buttons P1+P2 simultaneously and
the first three programs lights will come on.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “S TART PROGRAM ”. The program will resume from the point in
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.