Sharp KC-C100U - Manual (Page 16)

E-14
OPERATION
WATER SUPPLY INDICATOR LIGHT
When the Water Tank is empty, the Water Supply Indicator Light will flash
to indicate that the Water Tank should be refilled.
Please note the light
will not flash even when the Water Tank is empty during the Clean Air
Mode and the Quick Clean Mode.
Sound indicator setting for water supply.
In addition to the Indicator Light, the unit can be set to signal
with an audible beep when the Water Tank is empty. With the
unit OFF, press the Lights ON/OFF button for 3 seconds to turn
the audible signal ON.
Cancellation
To cancel the audible signal, with the unit OFF, press the Lights
ON/OFF button again more than 3 seconds.
ADJUSTMENT OF SENSOR DETECTION SENSITIVITY
Adjustment of Sensor Detection Sensitivity: Set to ‘low” if the DUST MONITOR is con-
stantly red to reduce sensitivity, and set to ‘high’ if the DUST MONITOR is constantly
green to increase sensitivity.
1
With the unit OFF, press the Fan Speed Button for 3 seconds.
The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The
factory setting is Standard, indicated by the MED light.
2
3
Press the Fan Speed Button to set
the desired sensor sensitivity.
Refer to the diagram on the right to select the
desired sensor sensitivity level.
Press the Power OFF Button.
Note that if the Power OFF Button is not pushed
within 8 seconds of adjusting sensor sensitiv-
ity, the setting will be saved automatically. The
sensor sensitivity setting will be saved even if
the unit is unplugged.
Sensor Detection
sensitivity
Fan Speed
Indicator Light
LIGHTS ON/OFF Button
Press this button to turn Front Panel monitor lights ON and
OFF.
High
Standard
Low
KC-C100U_Eng_N.indd 16 07.11.7 1:22:45 PM