SOYO SY-6BE+ - Manual (Page 7)

SY-6BE+ Quick Start Guide
7
Hardware Installation
Step 2.
Make Connections to the Motherboard
This section tells how to connect internal peripherals and power supply to the Motherboard.
Internal peripherals include IDE devices (HDD, CD-ROM), Floppy Disk Drive, Chassis Fan,
Front Panel Devices (Turbo LED, Internal Speaker, Reset Button, IDE LED, and KeyLock
Switch.), Wake-On-LAN card, VGA card, Sound Card, and other devices.
For more details on how to connect internal and external peripherals to your new SY-6BE+
Motherboard, please refer to SY-6BE+ Motherboard User's Guide and Technical Reference
online manual on CD-ROM.
Connectors and Plug-ins
PCI Audio Card Header: SB-Link ™ (PC-PCI) Wake-On-LAN Header: JP44
Pin1 Pin2 Pin3
Connect the SB-Link ™ (PC-PCI) cable from your
PCI audio card to this header. 5VSB GND MP-Wakeup
CPU Cooling Fan: CPUFAN Chassis Fan: CHAFAN
Pin1 Pin2 Pin3 Pin1 Pin2 Pin3
GND 12V SENSOR GND 12V SENSOR
Power LED Keylock
Pin1 Pin2 Pin3 Pin1 Pin2
5V NC GND Control Pin GND
Speaker
Pin1 Pin2 Pin3 Pin4
5V NC NC Speaker out
HDD LED Turbo LED PWRBT RESET
Pin1 Pin2 Pin1 Pin2 Pin1 Pin2 Pin1 Pin2
LED Anode LED Cathode LED Cathode GND Power On/Off GND Power Good GND
IrDA (Infrared Device Header): IR1
Pin1 Pin2 Pin3 Pin4 Pin5
VCC None IRRX GND IRTX
ATX Power On/Off: PWRBT ATX Power Supply: ATX PW
Connect your power switch to
this header (momentary switch
type).
To turn off the system, please
press this switch and hold
down for longer than 4
seconds.
Attach the ATX Power cable to this connector. (
This
motherboard requires an ATX power supply, an AT power
supply can NOT be used.)
Note: Please make sure the ATX power supply is able to
provide at least 720mA of current on the +5VSB lead if you
want to enable the advanced power management
functions, like Wake-On-LAN, Power-On by keyboard, etc.
Power LED Key Lock Speaker
Reset PWRBT Turbo LED HDD LED
+ +
+ +
_ _
_ _